Motor 2 Err: Diagnosis and Fix (Example)

Hey all!

I had a Motor 2 problem, where the right back motor was not working- it would spin for a second but not continue and power the board... & I fixed it!

This was shown with a 'Motor 2 Err' on the remote (found from the settings menu and status).

I then diagnosed and fixed the problem and wanted to share! As I think others could be having the same problem.

I consulted the Evolve error message list here. See remote control error messages.

I checked the wiring and found this:




This was from the wiring of Motor 2.

This wire was clearly shifted and went over the screw, which then was compressed when riding. I think this will be relatively easy to happen. This was the route of the Motor 2 Err.

The Fix:

1. Cut the Wire



2. Thread the wire ( I used a scalpel, but there are better tools.)
3. Re-connect wire




Last step: Cover the wire (I taped up)



SUCCESS!

Its works.

Also see my DIY waterproofing with clingfilm

Let me know if this helps anyone.

ND out x