can you drag board on its back wheels

I find it most comfortable to drag my board by holding it like a suitcase with my hand on the front truck. issue could be that I'm dragging it with the motorised wheels spinning on the floor. does this potentially damage the motors?

 

i do that with mine as well, i hope it doesn't......

 

Hope so too

 

Why not just grab the rear trucks and drag it “in reverse”? Nothing to worry about at all.

 

The motors are in the way

 

Huh, someone should have told me that before I effortlessly did it that way then...

Seriously, it’s not hard to pick up, and it’s not hard to hold. Best of all, it solves the problem OP was concerned about.

 

I do the same thing but at 6’3” I scratch the mounts. I can’t think of a reason why turning to motors would cause damage. It is as if you are free rolling. If the board is off that should not matter either. Beware as you raise the front of the board the motors ground clearance is lessened. I have scratched the motors as well pulling the board.

 

The motors will be fine.

 

i pefer ro drag it nose down