Show me your wheels!

Hey Everyone,

I would be interested in seeing everyone's different set ups they are running regarding wheels and hubs!

Whats types sizes and colours do you have! and what do you use them for. The good and the bad!!

I was going to try and do some water transfer films on my Evolve AT hubs, anyone tried?

-Milly

 

Anyone knows if these wheels would fit our GT Street Drive Gear?

 

I tried, it doesn't fit.

 

Should be able to 3D print a gear for them

 

Do you make them?

 

Looks like the same hub as the current street wheel from evolve or the abec11's. they should fit the board no problem, might need a little of the inside edge or just a spacer

 

Most likely using the clone hug spacing which has thicker cogs than the ABEC 11 based Evolve gear. I bought an extra set of gears and filed / dremeled them down to fit perfectly into the hub. Nice since now my set of wheels with spacers and bearings cost me only $28 and they work just as well as my ABEC 11 FlyWheels. These look great, especially since they have grooves.

When they didn't fit, did the width look like that'll fit? How do they compare in terms of width compared to the ABEC 11 97mm's?

 

So the ABEC 11's 97mm are 52mm in width, the MTB all terrain are 62mm and ABEC 11 107mm 75.5 mm.

The 107 ABECs won't work, too wide. The MTBs are 15mm wider than the ABEC 11 97mm wheels. So possibly they may just fit in there. I don't have my street wheels to eye it up. Would be cool.

 

The Evolve wheels are 54mm. I literally just measured them - the MTB wheels might not fit.

 

Not currently, wouldn't be that hard to design though.

 

You could use the black 97 clones that can be bought on eBay then instead of the expensive flywheels.
There is a market for those 3D printed drives then.

 

Yeah I just have no idea if they will be strong enough, only one way to find out, my clones should be arriving next week I hope.

 

I think you can see the MBS wheels in action here (in the snow), check the nice dragon wings which move up ;-)