New R2 controller with a loose Micro USB Port - LCD question

Hi there

I'm new to the Evolve family with a brand new Bamboo GTX AT, coming with the R2 controller.
I've got my board today. (and i can say, i loooove it!

But while the initial setup / charging, i mentioned a problem with the Micro USB Port on the R2 controller.
I tried to plug in the original Micro USB A to USB A cable to the controller, and the USB connector (female onboard) "went away!"
Thr connector was maybe not soldered to the PCB properly.

So i went for my first ride without charging the remote and i had a lot of fun!
Wow, i really like the board.

So after the ride, the remote battery was empty as well.
So, my dealer is out of office until friday. So my plan was to tear down the remote and fix the usb con. or solder some wires to the PCB, so that i could recharge the remote.

Everything went fine, but somehow i damaged the LCD displaywhile opening the remote.
This is my fault. But this wouldn't be the case, if the would find a proper design fort the usb connector...

So my question is:
Can i order the LCD-display by itself?
I don't think that they will replaice the controller, after i broke the LDC ;(

Could you give me an advice?

cheers
Fabian

 

yes, they sell it, just contact them. happened to me too.

 

thank you!